Before Requesting Help - Panasonic KX-TCD510BXM Operating Instructions Manual

510BX_e.book Page 72 Thursday, June 5, 2003 9:43 PM

Before Requesting Help

If you experience any problems with the normal use of your apparatus, you should
unplug it from the telephone outlet and connect a known working telephone in its place.
If the known working telephone still has problems, then please contact the customer
service department of your Telephone company.
If it operates correctly, then the problem is likely to be a fault in your apparatus.
In this case, contact your supplier for advice. Your Telephone company may charge you
if they attend a service call that is not due to an apparatus supplied by them.
Turn the power OFF then ON (Handset)/Disconnect then connect the AC adaptor
(Base Unit).
Problem
The unit does not work.
Display is blank.
Display is blank even
if the unit is charged.
Handset will not turn on.
Battery charge icon not
counting up.
icon flashes.
Handset busy tone heard
when is pressed.
No dial tone.
72
Possible cause
•
Batteries not installed
properly.
•
AC adaptor of base unit
not connected properly.
•
Handset not turned on.
•
Battery low.
•
Batteries not inserted.
•
Batteries not charged.
•
Dirty charge contacts.
•
Base not powered up.
•
Handset not registered to
base.
•
Handset out of range of
base.
•
No power into base unit.
•
Handset out of range of
base.
•
Another handset in use.
•
Telephone line not
connected.
Solution
•
Re-install batteries
properly.
•
Disconnect and then
connect AC adaptor.
•
Turn on power.
•
Recharge batteries more
than about 15 minutes.
•
Insert the 2 rechargeable
batteries supplied.
•
Place handset on base
and connect AC adaptor
to base and AC outlet
(full charge period 7 hrs).
•
Clean charge/battery
contacts and retry
charge.
•
Connect AC adaptor to
base unit and AC outlet.
•
Register handset to
base.
•
Move handset closer to
base.
•
Connect AC adaptor to
base unit and AC outlet.
•
Move handset closer to
base.
•
Wait for the other user to
complete call.
•
Insert telephone line cord
to network.
•
Turn power OFF then
ON.
Page
p.10
p.12
p.10
p.10
p.11
p.10
p.50
p.10
p.10
p.12