Settings Menu - Epson EB-925 User Manual

List of Functions

Settings Menu

Submenu
Keystone You can correct keystone distortion.
• When H/V-Keystone is selected:
• Correcting manually
Adjust V-Keystone and H-Keystone to correct
horizontal and vertical keystone distortion.
• Correcting automatically
Set Auto V-Keystone to On.
(This item cannot be selected if Projection is set to
Front/Ceiling, Rear, or Rear/Ceiling.)
s "Correcting automatically (Auto V-Keystone)"
• When Quick Corner is selected:
Select and correct the four corners of the projected image.
s "Correcting manually (Quick Corner)"
Control Panel You can use this to restrict operation of the projector's control
Lock panel.
s "Restricting Operation (Control Panel Lock)"
Function
p.36
p.37
p.61
Submenu
Pointer Shape You can select the shape of the pointer.
Pointer 1:
Pointer 2:
Pointer 3:
s "Pointer Function (Pointer)"
You can set the lamp brightness to one of two settings.
Power Consump‐
tion
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the power consumption and the lamp's
operating life are changed as follows, and fan rotation noise
during projection is reduced.
Electrical consumption: about 20% decrease, lamp life: about 1.2
times longer
Volume You can adjust the volume. Setting values are saved for each
source.
Adjust this if the microphone input level is low and the
Mic Input Level
microphone audio output from the projector's speaker is difficult
to hear, or if the input level is too high, resulting in a crackling
sound in audio from the microphone. When Mic Input Level is
turned down to 0, no microphone audio is output from the
speaker.
You can limit the reception of the operation signal from the
Remote Receiver
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control or
the control panel for at least 15 seconds to reset the setting to its
default value.
80
Function
p.52