The Remote Control Does Not Work; I Want To Change The Language For Messages And Menus; Mail Is Not Received Even If An Error Occurs With The Projector - Epson EB-925 User Manual

Problem Solving

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.

I want to change the language for messages and menus

Check
Change the Language setting.

Mail is not received even if an error occurs with the projector

Check
Is Standby Mode set to Communication On?
Did a fatal abnormality occur and the projector come to a sudden
stop?
Point the remote control towards the remote receiver.
s "Remote control operating range"
The operating range for the remote control is about 6 m.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.80
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.80
s "Replacing the remote control batteries"
Adjust the Language setting from the Configuration menu.
s Extended - Language p.81
To use the Mail Notification function when the projector is in standby, set Communication On in Standby Mode from
the Configuration menu.
s Extended - Standby Mode p.81
When the projector comes to a sudden stop, email cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
Epson Projector Contact List
s
Remedy
p.17
p.17
p.16
Remedy
Remedy
106