Phaser Effect - Midas PRO SERIES Owner's Manual

Phaser effect

Item
14
15
16
17
18
Phaser effect
The phaser effect consists of one, or if configured for dual operation, two stereo phasers
connected in serial/parallel according to mode setting.
1
1
Front panel of the phaser effect
Item
1
2
3
4
5
6
PRO Series Live Audio Systems
Owner's Manual
Control
Depth control
knob
Thru Zero switch
Spread control
knob
Shape control
knob
Rate control knob
3 2 14 15
3 2 13 12
Control
rate control knob
(channels 1 and 2)
manual control
knob (channels 1
and 2)
Modulation meter
hi eq control knob
lo eq control knob
gain control knob
Function
LFO Sweep section control for adjusting the intensity
of the effect by setting the depth of modulation as a
percentage. Interactive with Delay, as for Chorus.
Range is 0% to 100%.
LFO Sweep section control for selecting 'thru zero' or
normal mode. Illuminates to indicate switch is on.
LFO Sweep section control for setting the relative
phase of left/right modulation. Range is 0 to 180,
with 90 at top dead centre.
LFO Sweep section control for adjusting the shape of
the modulation waveform. Range is from Tri to Exp.
LFO Sweep section control for adjusting the rate of
modulation (Hz). Range is between 0.01 and 50,
with 0.7 at top dead centre.
16 17 18 19
11 10 9
Function
Controls the rate of modulation in Hz. Range is from
0Hz and 40Hz.
Sets the sweep offset or performing manual sweep.
Range is from 500Hz to 24kHz, with 3k5Hz (3,500Hz)
at top dead centre.
A single row of 15 yellow rectangular LED segments
are used to show the modulation on each channel.
Adjusts the amount of HF (high EQ) cut or boost
applied to the effect output (in dB). Range is from
-12dB to +12dB with 0dB at top dead centre.
Adjusts the amount of LF (low EQ) cut or boost
applied to the effects output (in dB). Range is from
-12dB to +12dB with 0dB at top dead centre.
Adjusts the signal level (dB). Range is from -20dB to
+20dB, with 0dB at top dead centre.
171
5 4 6
8 7