Table of Contents
Advertisement
TCD300FX(e).book Page 35 Monday, October 25, 2004 9:56 AM
2
Select "Erase", then press ,.
L To erase all messages, select "Erase
All", then press ,.
3
Select "Yes", then press ,.
4
Press {ih}.
Storing the sender's number in
the phonebook
1
While reading a received message,
press $ (middle soft key).
2
Select "Add Phonebook", then press
,.
3
Continue from step 3, "Adding entries to
the phonebook", page 16.
Editing the sender's number
before calling back
1
While reading a received message,
press $ (middle soft key).
2
Select "Edit and Call", then press
,.
3
Edit the number, then press {C}, {s},
or , to call.
Guide to SMS settings
If the base unit is reset to its default settings
(page 28), the following SMS-related
settings will be reset.
SMS settings
Default
setting
SMS on/off
Off
Message
Centre 1
Message
Centre 2
PBX line
Off
access number
Note:
L If the base unit is reset to its default
Storing the PBX line access
number (for PBX users only)
Store your PBX line access number (4 digits
max.) so that SMS messages are sent
properly. When sending SMS messages to
entries in the phonebook or redial list, the
PBX line access number will be deleted.
1
2
3
4
5
6
7
8
Page
page 32
—
page 32
—
page 32
page 35
SMS (Short Message Service)
settings, the contents of the receive and
send lists will be erased.
Press $ (middle soft key).
Select X, then press ,.
Select "Settings", then press ,.
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
28).
Select "PBX Access No.", then press
,.
Select "On", then press ,.
Enter your PBX line access code and a
dialling pause, if necessary, then press
, 2 times.
Press {ih}.
35
Advertisement
Table of Contents
