Table of Contents
Advertisement
TCD300FX(e).book Page 10 Monday, October 25, 2004 9:56 AM
Preparation
Battery installation
1
Insert the batteries negative (T)
terminal first.
2
Close the handset cover.
Note:
L Use only rechargeable batteries (page 5).
Battery charge
Place the handset on the base unit for
about 7 hours before initial use.
When charging, i and battery strength
icon are alternately shown on the display.
10
When the batteries are fully charged, 1
flashes.
Note:
L It takes 7 hours to fully charge the
batteries, however, you can use the
handset before the batteries are fully
charged.
L Clean the charge contacts (page 7) of the
handset and base unit with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Battery icon
Battery strength
High
1
Medium
2
Low
3
When flashing: Needs
to be charged.
Note:
L When 3 flashes, recharge the handset
batteries. 3 will continue to flash until
the batteries have been charged for at
least 15 minutes.
L If the handset is turned off, it will be turned
on automatically when it is placed on the
base unit.
Advertisement
Table of Contents
