Program End Search - Panasonic PV-DM2792 Operating Instructions Manual

* Important: If a remote control button does not work when pressed, press the
and try the button again.
button on the remote

Program End Search

Locates end point of recording for continuity.
1
Press SEARCH twice in Playback or
Stop mode to display PROGRAM
END SEARCH screen .
2
Press FF
PROGRAM END SEARCH
to start search.
To cancel,
SEARCH START : FF
press PLAY or STOP.
EX I T : SEARCH
Example of Program End Search operation.
Fig.1
PLAYBACK DIRECTION
Program 1 Program 2 or BLANK
Press SEARCH button
End Point
FF
Fig.2
Program 2
Program 1 BLANK
Press SEARCH button
FF
Fig.3
If search exceeds a few seconds in BLANK area.
Press SEARCH button
Program 1 BLANK
FF
End Point
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
Press SEARCH button
Note
• If Program End Search is started very close
to an index mark, that mark may be
skipped over.
BLANK
End Point
Program 2
35