Table of Contents
Advertisement
2. Installing the Copier
Power Source
CAUTION: Plug Socket
• A plug socket is limited in capacity. Use only a power source with the correct rating for the
machine; otherwise, hazardous situations such as smoking or overheating may occur. See the to
match the power supply and power consumption:
a) 230V/50 Hz: Less than 3.5A
b) 230V/60 Hz: Less than 3.5A
• Avoid multiple connections in the same outlet. Do not use multiple outlet adaptors.
CAUTION: Power Plug and Lead
• Be sure to insert the power plug firmly into the power socket. Otherwise an accident may occur
as a result of smoking or overheating. If the inserted power plug is loose in the socket, even after
it has been positively inserted, disconnect the plug and contact your electrical contractor.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• Do not bend or crush the power lead. If your copier power lead is bent or damaged in any way,
contact your Service Centre immediately. Do not attempt to repair it yourself, and do not
continue to operate the copier. A damaged power lead may result in overheating, a short circuit,
or fire.
• Do not bundle or coil the power lead of the copier. Otherwise an accident may occur as a result
of overheating or fire.
CAUTION: Connecting Multiple Loads to One Socket Outlet Prohibited
Never connect multiple loads to one socket outlet using a multi-outlet extension lead or
branched socket. Otherwise an accident may occur as a result of overheating or fire.
CAUTION: Extension Lead
An extension lead should never be used with this copier.
Machine Installation
CAUTION: Prevention of Fire
Do not install near flammable materials, curtains and volatile combustibles, that can catch or
cause fire.
CAUTION: Prevention of Short Circuit
Do not install the copier where it could be splashed with rain water, or water from tap, to avoid a
short circuit.
1-5
Advertisement
Table of Contents
