Receiving A Message - Panasonic KX-TCD210E Operating Instructions Manual

TCD210220E(e-e).book Page 40 Tuesday, January 18, 2005 9:44 AM
SMS (Short Message Service)
Select the desired mailbox, press {>},
then enter its password.
4
Select "Send List", then press {>}.
5
Press {e} or {v} repeatedly to select
the message, then press {j/OK}.
6
Press {j/OK}, select "Erase", then
press {>}.
L To erase all messages in the selected
mailbox, select "Erase All", then
press {>}.
7
Select "Yes", then press {>}.
8
Press {ih}.

Receiving a message

When an SMS message is received:
– a tone is heard (if the ringer is turned off,
this tone is not heard)
– "Receiving SMS Message" is
displayed
– F is displayed
Reading a received message
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
To access the public mailbox
Select "Public", then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
L If a mailbox contains new (unread)
SMS messages, "@" is displayed next
to the total number of messages for
that mailbox.
4
Select "Receive List", then press
{>}.
5
Press {e} or {v} repeatedly to select a
message.
L Messages which have already been
read are indicated by a "Q", even if
they were read using another handset.
40 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
6
Press {j/OK} to read the message
content.
Note:
L To call the message sender, press {C}
or {s}.
L If "SMS Full" is displayed, new SMS
messages cannot be received. Erase
unnecessary messages (page 39, 40).
L If you receive a message from a party
saved in the handset phonebook, the
stored name is displayed.
L Some SMS service providers attach a 1-
digit number to the message sender's
phone number, and sender names stored
in the handset phonebook may not be
displayed as a result.
Replying to a message
1
While reading a received message,
press {j/OK}.
2
Select "Reply", then press {>}.
3
Enter a message (page 43), then press
{j/OK}.
4
Edit the destination phone number
and/or press {j/OK}, then continue
from step 7, "Writing and sending a new
message", page 38.
Editing/forwarding a message
1
While reading a received message,
press {j/OK}.
2
Select "Edit Message", then press
{>}, then continue from step 5, "Writing
and sending a new message", page 38.
Erasing received messages
1
While reading a received message,
press {j/OK}.
2
Select "Erase", then press {>}.
L To erase all messages in the selected
mailbox, select "Erase All", then
press {>}.