Table of Contents
Advertisement
TCD210220E(e-e).book Page 62 Tuesday, January 18, 2005 9:44 AM
Useful Information
Problem
While storing an entry in the
phonebook or assigning a one
touch dial, the handset starts to
ring.
Pressing {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 7 flashes.
I fully charged the batteries, but
7 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to a
base unit.
62
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L A call is being received. To answer the call, press
{C}. Programming will be cancelled. Start again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 11).
L Clean the charge contact and charge again (page
11).
L It is time to replace the batteries (page 12).
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L Do not pause for over 1 minute while searching.
L The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (page 54).
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 53).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Locate the handset and the base unit away from
other electrical appliances.
Hide quick links:
Advertisement
Table of Contents
