Advertisement
QuickSpecs
Systems
Step 2b - Disk Drive Cage - Mandatory
Step 2b - Disk Drive Cage - Mandatory
Step 2b - Disk Drive Cage - Mandatory
Step 2b - Disk Drive Cage - Mandatory
Systems support one disk drive cage; disk drive cage supports six 3.5-inch hard disk drives
6-bay disk drive cage
Step 2c - SCSI Adapter - Mandatory
Step 2c - SCSI Adapter - Mandatory
Step 2c - SCSI Adapter - Mandatory
Step 2c - SCSI Adapter - Mandatory
Selection of LVD SCSI adapter to connect to internal disk drive cage is mandatory; SCSI cable included with disk-drive
cage
Single-channel LVD adapter, maximum four per system
PCI 2-channel multimode Ultra3 LVD SCSI adapter VHDCI (Tru64 UNIX 5.1 or higher and OpenVMS
V7.2-2 or higher)
NOTES:
NOTES
NOTES
NOTES
Patch kit required, kit available at
No shared bus support with OpenVMS. No shared tape/library support with OpenVMS or Tru64
UNIX. 3X-KZPEA-DB adapter supports shared bus using hard disk drives under Tru64 UNIX
V5.1A with Patch Kit 4 or V5.1B with Patch Kit 1 and TruCluster V5.1A; supports maximum of
two nodes per shared bus, requires
3X-BN55A-01 Y-cable and connector plug assembly and 3X-H32CT-AA external LVD terminator
per shared bus.
Refer to 3X-KZPEA-DB QuickSpecs for complete list of restrictions.
PCI-to-10/100 MBPS Ethernet, graphics, LVD SCSI combination adapter, maximum one per system
(cannot be installed in PCI slot 1)
PCI 1-channel Ultra2 LVD backplane RAID controller, 64-bit, 16-MB cache
NOTES
NOTES
NOTES:
NOTES
Supported with BA610-6D, BA356, and DS-SL13R-xx or DS-SSL14-RX shelves only. When
installed in BA356 shelves, part number DS-BA35X-FC is required for non-factory installations.
Graphics card is required to run the DS-KZPCC-AC console utilities (SMOR) with SRM console
versions lower than V6.0 or, alternatively can be run via serial line and terminal emulation
software for SRM V6.0 or higher. PB2GA-JC/JD graphics cards are not
supported.
EV6 systems not supported.
Supported in platform part numbers: DA-56PAB-EA/FA/EW/FW and DA-56RAA-
EA/FA/EW/FW.
Specific patches are required for specific versions of the operating system. See
DS-KZPCC-AC/CE QuickSpecs for latest details and other configuration information.
Tru64 UNIX V4.0F requires NHD3 and Patch Kit 4 (BL15) or later
Tru64 UNIX V5.1 requires Patch Kit 3 (BL17) and Early Release Patch C462
Patch Kit 3 (BL17) is located at:
T64V5117-C0046202-11060-Manual-ER-20010615.tar
Patch C462.02 is located at:
http://ftp1.support.compaq.com/public/unix/v5.1/
DS-KZPCC-AC/CE RAID controllers support standalone and cluster configurations; no support
as boot device or primary device in cluster configurations; TruCluster V5.1 (restricted to non-
shared buses only)
PCI 3-channel Ultra2 LVD RAID controller, 64-bit, 64-MB cache
NOTES
NOTES
NOTES
NOTES:
Supported with BA610-6D, BA356 and DS-SL13R-xx or DS-SSL14-RX shelves only. When
installed in BA356 shelves, part number DS-BA35X-FC is required for non-factory installations.
Graphics card is required to run the DS-KZPCC-AC console utilities (SMOR) with SRM console
versions lower than V6.0 or, alternatively can be run via serial line and terminal emulation
software for SRM V6.0 or higher. PB2GA-JC/JD graphics cards are not supported.
EV6 systems not supported.
http://ftp1.support.compaq.com/public/Digital_UNIX/v5.1/
DA - 10445
North America — Version 37 — October 24, 2003
Compaq AlphaServer DS20E
Compaq AlphaServer DS20E
Compaq AlphaServer DS20E
Compaq AlphaServer DS20E
Compaq AlphaStation DS20E
Compaq AlphaStation DS20E
Compaq AlphaStation DS20E
Compaq AlphaStation DS20E
BA610-6D
3X-KZPCA-AA
3X-KZPEA-DB
3X-DEPVZ-AA
DS-KZPCC-AC
DS-KZPCC-CE
Page 5
Advertisement
