Standby Mode - Panasonic Viera TX-26LXD60A Operating Instructions Manual

Problem
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
No sound is produced
Sound level is low
or sound is distorted
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Interference or
frozen / disappearing
image in DVB
Unable to receive signals
with a high-performance
aerial
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
"Control with HDMI"
function does not work
TV unit goes into

"Standby mode"

The remote control
does not work
Actions
•
Set "P-NR" in the Picture menu (to remove noise). (p. 21)
•
Check nearby electrical products (car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 21)
•
Reset channels. (p. 28 and p. 30)
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set "NICAM" (p. 20) in the Sound menu to "Off".
(Analogue only)
•
Check "Signal Condition". (p. 28)
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial.
If problem persists, consult your local Panasonic dealer.
•
Use the remote control to turn Off the TV unit, then turn
it On again.
•
Install an aerial individually for the TV unit and VCR
(or use a splitter).
TV
Aerial
Input
terminal
VCR
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 21)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 21)
•
Is the HDMI cable connected properly? (p. 40)
•
Turn Off the TV unit and equipment, then turn them On
again.
•
Check an input signal from the equipment. (p. 43)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again. (p. 38)
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
•
Are the batteries installed correctly? (p. 6)
•
Has the TV unit been switched On?
(Individual aerial)
Splitter
Aerial Output
Aerial Input
Aerial Output
(Individual aerial)
45