Service MODE
How to enter Service 1
•
Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the
remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1.
Key Command
•
Press the RED / GREEN buttons to step up / down through the functions.
•
Press the YELLOW / BLUE buttons to alter the function values, to alter White Rasters use +/- buttons
•
Press the OK button after each adjustment has been made to store the required values.
•
To exit the Service Mode, press the "N" button.
Keep adjusting sequence: DVCO, Sub-Contrast, other items.
Item
Sub-Contrast
DVCO
Highlight
Lowlight
Sub-Brightness
Setting indication
Note: All setting values are approximate
Sub-Contrast
32
DVCO
63
High
12
0410
0410
Low
4
0064
0064
Sub-Brightness
0
Receive PAL colour bar (100% white) RF signal with
correct sound system (B/G, D/K) via aerial input. For
Sub-Contrast alignment press "Blue" button, wait until
the figure colour is changed from red to black colour.
Receive PAL colour bar (100% white) RF signal via
aerial input. For DVCO alignment press "Blue"
button, wait until the figure colour is changed from red
to black colour. Press the OK.
0304
For correct setting see White Balance Adjustment
0064
12
Settings / Special features
Press the OK.
Optimum setting.