Cancelling A Base Unit; Cancelling A Handset - Panasonic KX-TCD200G Operating Instructions Manual

TCD200G(e-g).book Page 29 Tuesday, February 8, 2005 8:57 AM
L If you changed the PIN, enter it (Seite 25).
L When the handset has been registered
successfully, w will stop flashing. If
keytones are turned on (Seite 20), a
confirmation tone will be heard.
Selecting a base unit
When "Automatisch" is selected, the handset
will automatically use any available base unit it is
registered to. When a specific base unit is
selected, the handset will make and receive calls
using that base unit only. If the handset is out of
range of that base unit, no calls can be made.
1
Press {j/OK}.
2
Select "Mobilteileinst.", then press
{>}.
3
Select "Auswahl Basis", then press {>}.
4
Select the desired base unit number, or
"Automatisch", then press {>}.
L The handset starts searching for the base
unit.

Cancelling a handset

A maximum of 6 handsets can be registered to a
base unit. A handset can cancel its own
registration (or the registration of another
handset) that is stored in the base unit. This will
allow the base unit to "forget" the handset.
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 25).
4
Enter "335".
5
Select "Mobilt. Löschen", then press
{>}.
L The numbers of all handsets registered to
the base unit are displayed.
6
Select the handset(s) you want to cancel, by
pressing the desired handset number.
L The selected handset number(s) will flash.
L To cancel a selected handset number,
press the number again. The number will
stop flashing.
7
Press {j/OK}.
Multi-unit Operation
8
Select "Ja", then press {>}.
9
Press {ih}.

Cancelling a base unit

A handset can be registered to a maximum of 4
base units. A handset can cancel a base unit that
it is registered to. This allows the handset to
"forget" the base unit.
1
Press {j/OK}.
2
Select "Mobilteileinst.", then press
{>}.
3
Select "Registrierung", then press {>}.
4
Enter "335".
5
Select "Lösche Basis", then press {>}.
6
Enter "0000" (default handset PIN).
L If you changed the PIN, enter it (Seite 20).
7
Select the base unit(s) you want to cancel, by
pressing the desired base unit number.
L The selected base unit number(s) will
flash.
L To cancel a selected base unit number,
press the number again. The number will
stop flashing.
8
Press {j/OK}.
9
Select "Ja", then press {>}.
10
Press {ih}.
Hinweis:
L To register the handset to another base unit or
to the same base unit again, see manual
registration (Seite 28).
Increasing the range of the base unit
You can increase the range of the base unit by
using a DECT repeater. Please use only the
Panasonic DECT repeater noted on Seite 4.
Consult your Panasonic dealer for details.
Wichtig:
L Before registering the repeater to this base
unit, you must turn the repeater mode on.
Turning the repeater mode on/off
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
29