= Note =
When this TV is turned on for the first time, or the TV is switched off for
●
more than a week, it may take some time before TV Guide is completely
shown.
This function varies depending on the country you select.
●
The postcode entry or update may be required to use the GUIDE Plus+
●
system depending on the country you select.
DVB-T and Analogue channels are displayed on the same TV Guide
●
screen.
D
and
A
may be displayed to distinguish DVB-T and Analogue
channels. There will be no programme listings for Analogue channels.
Timer Programming
The Timer Programming menu allows you to choose programmes that you
want to remind watching or record to the USB HDD. At the correct time, the
TV will tune to the correct channel even if the TV is in Standby mode.
1. Select the forthcoming programme or channel with
press
OK
to access
2. Select
USB HDD Rec.
To check / change / cancel a timer programming event
●
Recording
LED will turn to orange in Standby mode if
●
To return to TV Guide
●
BACK/RETURN
If you select the current programme, a confirmation screen asking
●
whether you want to watch or record the programme appears. Select
Timer Programming
record from the time you finish the timer programming event setting.
Depending on the country you select, you can set
●
Recording
(see below).
= Note =
Not valid in Analogue mode
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
Depending on the progress of recording, analogue channel may not be
●
selected.
When recording programmes to the USB HDD, be sure to format the USB
●
HDD and enable it to record in
Recording
/
Reminder
with
Timer Programming
with
/
and press
only works reliably if correct time information is
USB Device
USB HDD setup
- 46 -
/
/
/
and press
OK
to set
Editing timer programming
Timer Programming
OK
to set
USB HDD Rec.
Signal Supported
Setup.
/
and
is set.
to