Operation - Lervia KH 1410 Operating Instructions Manual

Cyclone vacuum cleaner
Hide thumbs Also See for LERVIA KH 1410:
Table of Contents

Advertisement

1. Insert the suction pipe connector
into the socket on the vacuum cleaner
until the locking device engages.
2. Insert the hand grip
end of the telescope tube
firmly seated.
3. Place the desired tool (floor tool
crevice tool
2$
or upholstery brush
see chapter "Changing tools") on the
lower end of the telescope tube
4. Adjust the telescope tube
desired length: Press the height
adjustor
1&
down. Pull the telescope
tube
1(
apart on the hand grip
When you have the desired length
release the height adjuster
the telesopic tube
until it audibly engages.
The Cyclone Vacuum Cleaner is now
ready for use.
Changing tools
When you want to change the tool,
proceed as follows:
1. Select the desired tool:
Floor tool
f
:
To vacuum carpets or
hard floors.
Crevice tool
2$
: To vacuum dust from
difficult to reach loca-
tions.
Upholstery
2%
brush
:
To vacuum dust from
upholstery
or other fabric
surfaces.
2. Switch the machine off at the On/Off
switch
t
.
j
2#
into the upper
1(
until it is
f
,
2%
,
1(
.
1(
to the
2#
.
1&
. Pull
1(
a little further
Attention! Remove the plug
the wall socket. The appliance could
be inadvertantly switched on.
3. Remove the fitted tool from the tele-
scopic tube
1(
4. Place the desired tool on the lower
end of the telescopic tube
5. Store the no longer required tools as
far as practicable in the accessory
2)
bracket
.

Operation

Attention! Before every utilisation
check to ensure that all filters are
correctly inserted and that no ope-
nings are blocked. The filters must
show no sign of damage and must
be dry. If not, there is a risk of over-
heating!
1. Fit the required tool (see chapter
"Changing tools").
2. Pull the power cable
cable storage up to the yellow mar-
king.
Attention! Should the red marking
on the power cable
rewind the power cable
sing on the foot button for power
cable rewind
marking. Otherwise, the power
o
cable
could break off.
3. Press the On / Off switch
4. Adjust the suction power with the
suction power regulator
- 6 -
o
from
.
1(
.
o
from the
o
be visible,
o
, by pres-
i
, back to the yellow
t
.
u
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kh 1410

Table of Contents