Emptying The Dust Collector - Lervia KH 1410 Operating Instructions Manual

5. If you are using the floor tool
adjust the setting for carpet/hard
floor d with the selector switch:
• Press the carpet/hard floor selector
switch d to the rear for hard floor
surfaces such as laminates, tiles and
PVC etc.
• Press the carpet/hard floor selector
d
switch to the front for carpeted
surfaces, such as long or short pile
carpets and rugs etc.
6. Pull the vacuum cleaner after you like
a sledge. When vacuuming, pay heed
to the information providet by the
floor covering manufacturer.
Notice: Should you need to reduce
the suction power, e.g. if a curtain is
sucked in, open the secondary air
2@
regulator .
7. Press the On/Off switch
the vacuum cleaner off.
8. Remove the power plug
wall socket.
9. Hold the power plug
press on the foot button for power
cable rewind i . Allow the power
cable o to pull itself in slowly.
f ,
t to switch
o from the
o firmly and
- 7 -

Emptying the dust collector

Empty the dust collector
when the MAX marking
the suction power has noticeably dimi-
nished.
Attention! Before emptying the dust
h
collector , remove the plug
the power socket.
1. Press the unlock button
the housing lid s
2. Turn the dust collector
so that it can be lifted out.
3. Hold the dust collector
dustbin and press the dust collector
unlock button .
4. Carefully knock the dust deposits out.
5. Close the bottom
6. Replace the dust collector
vacuum cleaner. The lateral lugs
must fit into the recesses in the vacuum
cleaner.
7. Turn the dust collector
can no longer be lifted up.
8. Close the housing lid
h at the latest
is reached or
o
from
w and open
.
h to the side
h low over a
.
h
into the
h so that it
s .