Table of Contents
Advertisement
USB 1.1 Ports Configuration [USB 8 Ports]
Allows you to set the number of USB ports to activate.
Configuration options: [Disabled] [USB 2 Ports] [USB 4 Ports] [USB 6 Ports]
[USB 8 Ports]
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 controller.
Configuration options: [Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB devices at startup. If detected,
the USB controller legacy mode is enabled. If no USB device is detected, the
legacy USB support is disabled. Configuration options: [Auto] [Disabled] [Enabled]
USB 2.0 Controller Mode [HiSpeed]
Allows you to configure the USB 2.0 controller to HiSpeed (480Mbps) or FullSpeed
(12Mbps). Configuration options: [HiSpeed] [FullSpeed]
2.4.3 Onboard Devices Configuration
Floppy Disk Controller
Onboard PCI IDE Controller
OnBoard AC'97 Audio
OnChip SATA BOOTROM
OnBoard LAN
Onboard LAN Boot ROM
Serial Port1 Address
Serail Port2 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
Floppy Disk Controller [Enabled]
Enables or disables the Floppy Disk Controller.
Configuration options: [Enabled] [Disabled]
2-18
[Enabled]
Allows BIOS to Enable
[Both]
or Disable Floppy
[Enabled]
Controller.
[Enabled]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378]
[ECP]
[DMA3]
[IRQ7]
Chapter 2: BIOS information
Advertisement
Table of Contents
