Agitator Motor Overload Protection; Operation; Thermal Overload Protection; Led Headlight - Kenmore Premalite VF6712TC Use And Care Manual

78017_Kenmore vac_EN_final

Agitator Motor Overload Protection

The agitator has a built-in protection
against motor damage should the
agitator jam.
If the agitator stops, the agitator
overload protector shuts off the
agitator motor. The suction motor
will remain on at this time.
To correct problem: Turn off and
unplug vacuum cleaner, remove
obstruction, and press the RESET button.
When vacuuming, if the agitator is
not running at full speed due to an
obstruction in the agitator area, the
agitator "ON/OFF" LED will begin a
series of three flashes followed by
a pause.
To correct problem: Turn off and
unplug vacuum cleaner, then remove
obstruction from the agitator.

Thermal Overload Protection

This vacuum cleaner has a thermal
overload protector which automatically
activates to protect the vacuum cleaner
from overheating. If a clog prevents the
normal flow of air to the motor, the
thermal protector turns the motor off
automatically to allow the motor to cool
in order to prevent possible damage to
the vacuum cleaner.

LED Headlight

The LED headlight will come on when
the vacuum cleaner is on.
10/17/07 9:00 AM

OPERATION

Carpet
Floor
Agitator ON/OFF
(Main Vacuum Cleaner Motor)
To correct problem: Turn the vacuum
cleaner off and unplug the power cord.
Check for and remove clogs, if
necessary. Also check and
clean/ replace any clogged filters.
Wait approximately 30 minutes and
plug the vacuum cleaner in and turn
back on to see if the motor protector
has reset. The thermal protector system
will not reset until the vacuum cleaner
has cooled down.
14
Page 14
ON
OFF
POWER
HEIGHT ADJUSTMENT
Hi
Med
Lo