Zanussi ZKN 7124 User Manual page 25

After removing all the
packaging, carefully lay
machine on it's back to re-
move the polystyrene base
from the bottom.
Unscrew the three bolts.
Open the porthole and re-
move the polystyrene
block fitted on the door
seal.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by rais-
ing or lowering the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the machine MUST
be level and stable.
Any necessary adjustment can be made with a spanner.
www.zanussi.com
Remove the power supply
cable and the hoses from
the hose holders on the
rear of the appliance.
Slide out the relevant plas-
tic spacers.
Fill the smaller upper hole
and the two large ones
with the corresponding
plastic plug caps supplied
in the bag containing the
instruction booklet.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
Rubber feet kit (4055126249)
Available from your authorized dealer.
The rubber feet are particularly recommended on floating,
slippery and wooden floors.
Mount the rubber feet to prevent vibration, noises and dis-
placement of the appliance during operation.
Read carefully the instructions supplied with the kit.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to new
pipework or to pipework that has not been used for
some time, run off a reasonable amount of water to flush
out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
If necessary, check the
setting with a spirit level.
Connect the hose to a tap
with a 3/4" thread. Always
use the hose supplied with
the appliance.
25