Maytag MDG4057BWW Installation Instructions Manual page 18

Connect the neutral (white) conductor of the cord to the center (silver colored) post of the
terminal block. Connect the grounding (green) wire of the cord to the terminal block support
using the ground strap screw.
Connect the red and black wires of the cord to the outer posts of the terminal block.
Be sure the termini block nuts are on tight. Secure the power cord in position. Tighten the
strain relief screw(s) in order to clamp the strain relief to the cord.
Replace the terminal block cover.
WARNING: If converting from 4-wire electrical systems to 3-wire, the ground strap must
be reconnected to terminal block support to ground the dryer flame to the neutral conductor
A
/
Terminal Block
Cover Plate
B
Terminal
Block "_
Terminal
Block ._
Suppor_
C)
o
3-Wire System
/
Ground
Strap
/
Ground
Strap
Screw
Hole for
power cord
_" and
strain relief