Table of Contents
Advertisement
6.
GAS DRYER
SECTION
To Make Gas Connection
- Review gas requirements
in previous
section of these instruc-
tions.
1. Remove
the pipe thread protective
cap.
,
Apply pipe joint compound
or about 1 1/2 wraps of Teflon tape over atl threaded
connections.
NOTE:
Pipe joint compound
must be resistant
to the action of an},
liquefied
petroleum
gas.
.
,
Connect
the gas supply to the dryer.
An additional
fitting is required
to connect
the 3/4"
female threaded
end of a flexible connector
to the 3/8" male threaded
end
on the dryer.
Securely
tighten the gas line fitting over threads.
Turn on the gas supply.
Check all gas connections
for leaks using a soap
solution.
If bubbles
occur, tighten the connections
and recheck.
DO NOT use an
open flame to check for gas leaks.
Hide quick links:
Advertisement
Table of Contents
