Table of Contents
Advertisement
INSTALLATION REQUIREMENTS
TOOLS
AND
PARTS
Gather the required tools and parts before starting installation.
Tools
needed:
Parts supplied
(all models):
Flat-blade screwdriver
#2 Phillips screwdriver
Leveling legs (4)
Wire stripper (direct wire
installations)
Tin snips (new vent
installations)
1/4" and 5/16" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Tape measure
Level
Pliers
Caulking gun and
compound
(for installing
new exhaust vent)
Parts supplied
(steam models):
"Y" connector
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
Parts needed:
(Not supplied with dryer)
[] Vent clamps
[] Vent elbows and vent work
Parts needed (steam models):
2' (0.6 m) inlet hose
5' (1.52 m) inlet hose
and rubber washer
Additional parts may be required, depending
in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
if using a power
supply
cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
[] A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
[] A UL listed strain relief.
Optional
Equipment:
(Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories
available for your dryer.
Hide quick links:
Advertisement
Table of Contents
