Table of Contents
Advertisement
LEVEL DRYER
1.
Level dryer
Place
level here
Check levelness of dryer from
side to side. Repeat from front to back.
©
NOTE: The dryer must be level for the moisture sensing system
to operate correctly.
Not Level
LEVEL
Not Level
2.
Adjust
leveling
legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and dryer does not rock.
COMPLETE INSTALLATION
CHECKLIST
[_ Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
[_ Check that you have all of your tools.
[_ Dispose of/recycle all packaging materials.
[_ Be sure the water faucets are on.
[_ Check for leaks around "Y" connector, faucet, and hoses.
[_ Check dryer's final location. Be sure vent is not crushed
or kinked.
Check that dryer is level. See "Level Dryer."
Remove film on console and any tape remaining on dryer.
Wipe dryer drum interior thoroughly
with a damp cloth to
remove any dust.
Read "Dryer Use" in your "Use and Care Guide."
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on Power.
If you live in a hard water area, use of a water softener is
recommended
to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which
will reduce product performance.
Excessive scale buildup
may lead to the need for certain part replacement
or repair.
[_ Select a Time Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or "On" position.
= Start button has been pushed firmly.
= Dryer is plugged into an outlet and/or electrical
supply.
= Household fuse is intact and tight, or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically
runs an installation diagnostic
routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated.
This odor is common when heating element is first used.
The odor will go away.
17
Hide quick links:
Advertisement
Table of Contents
