Hoover HP6 110M Instructions For Use Manual page 7

40000693.qxd 13/11/2003
Note: we recommend you keep the transit bracket and
screws to protect the machine for future transit.
The Manufacturers will not be responsible for any
damage to the machine caused by not following the
instructions relating to releasing the transit protection.
The user is responsible for all installation costs.
Connecting the Cold Fill Hose
This Appliance must be connected to a COLD WATER
supply only
Only one hose is required to install this machine to a cold water supply.
Cold fill is an energy efficient system. Only the water required to wash the laundry
is heated. There is no loss of heat in the pipeline from the hot water tank or the
boiler.
If your previous machine installation was hot and cold fill ensure that the hot tap is
firmly closed to prevent leakage.
Connection to the cold supply
The machine has an inlet hose with 19mm (3/4") threaded ferules fitted to the
end. This hose connects between the threaded connector on the rear of the
appliance and the water supply.
Only use the new hose supplied to connect the machine and ensure that the
sealing washers are in place inside the hose connectors.
Do not re-use an old hose which was attached to the existing installation.
Do not over-tighten the connections. Hand tight is sufficient.
Do not trap or kink the hose.
16:45 Page 7
7