Installationinstructions - KitchenAid KBHS179SSS06 Installation Instructions Manual

INSTALLATIONINSTRUCTIONS
4. Remove the bottom vent (bottom vent will be reattached after
_};_"@_}GI_@#_, I{ _" # j M C_©WGV@ C_3w'_C:_,_,_ _z_::: _< _ , the microwave oven is installed).
1. Locate existing wiring to avoid drilling into or severing wiring .............................. \_
\,
during installation.
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the microwave oven onto
cardboard prior to installation. Do not use the handle or any
portion of the front frame for lifting.
3. Remove the shipping materials and tape from the microwave
oven.
4. Remove and set aside racks and other items from inside the
microwave oven.
5. Remove the hardware package from inside the bag
containing literature.
6. Move the microwave oven and cardboard close to the
microwave oven's final location.
1=
Attach the bottom vent to the spacer bars using two Phillips
head screws, Be sure to use the top, center hole in the spacer
bars,
NOTE: Guide flanges should face inward.
D
//i:i/
....... C
A. Bottom vent
B. Spacer bars
C. Phillips head screws
D. Guide flanges
1. Center the assembled microwave oven spacer kit in the
cabinet cutout. Push the spacer kit back into the cabinet
cutout until the bottom trim is flush with the cabinet front.
2. Using a 1/8"(3.2 mm) drill bit, drill through the mounting holes
in the spacer bars into the microwave oven support surface
to create pilot holes.
3. Attach the assembled spacer kit to the support surface using
four 3A" pan head screws provided. Do not overtighten the
screws.
A. 3/4"pan head screws
B. Spacer kit assembly
C. Bottom vent
Electrical Shock Hazard
Disconnect power before servicing.
Use 12 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This microwave oven is manufactured with a neutral (white)
power supply wire and a cabinet-connected green (or bare)
ground wire twisted together.
1. Disconnect power.
2. Feed the flexible cable conduit from the microwave oven
through the opening in the cabinet.
3. Remove junction box cover if it is present.
4. Install a UL listed or CSA approved conduit connector to the
junction box.
A .............
A. UL listed or CSA approved conduit connector
5. Route the flexible cable conduit from the microwave oven to
the junction box through a UL listed or CSA approved conduit
connector.
6. Tighten screw on conduit connector.
7. See "Electrical Connection Options Chart" to complete
installation for your type of electrical connection.
6