Bottom Sound Pad Installation (On Some Models) - KitchenAid KUDS30FXWH1 Installation Instructions Manual

NOTE: Youmustdrill pilotholes incabinet to avoid
splitting thewoodbefore installing screws.
If securing w itha sideattachment, check thatsides of
doordonotrubagainst thescrew heads. Iftheydo,
dishwasher mustbere-centered. When dishwasher is
properly c entered, replace plastic buttons.
Remove t owelfromdishwasher. Reinstall thelower dish
rack.
If needed, seewebsite foranimated r epresentation
ofthisstep.Visitwww.Mtchenaid.corn/anchoring under
FAQ tab.
Bottom Sound Pad Installation
(on some models)
1. Remove the bottom sound pad from inside the
dishwasher and take it out of the plastic bag.
2. Place pad on the floor in front of the dishwasher,
making sure lettering is facing up and vinyl pad faces
down.
3. Fold up and hold the side panels down. Slowly slide
the pad toward the back of the dishwasher as far as it
will go, making sure not to push or pull any wires or
hoses. (Do not force.) Side panels will open to proper
position.
NOTE: If there are pipes or other obstructions coming
up through the floor, you will need to cut a slit in the
pad to fit around the obstacle.
4. Fold the front end of the pad up into position. Make
sure the vinyl pad is tucked up behind the door and
the dishwasher front legs, as shown.
_iiiiiiiiiiiii_i/i/_ iiiiiii
Complete Installation
23