KitchenAid KUDS30FXWH1 Installation Instructions Manual page 13

Electrical
Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
--" Connect ground wire |
--_.
Remove the green grounding screw and place
through the ring terminal of the green ground wire.
Reattach and tighten the green screw.
NOTE: Twist on wire connector. Gently tug on wires to be
sure both are secured.
Connect wires black to black and white to white, using UL
Listed!CSA Approved twist-on wire connectors (included
with power supply cord kit).
P0wei Supp!y wire: Terminal box Wire:
.... white _ white I
black _ b!ack i
g[ound w!re _ ground connector
If needed, see website for animated representation of this
step. Visit www.kitchenaid.eom under FAQ tab.
Tighten strain relief screws to secure cord.
0
Place wires inside terminal box. Insert tabs
on left side of cover. Make sure wires are tucked inside
box. Close cover ensuring wires are not pinched. Use 1/4"
nut driver and previously removed screw to secure
cover.
NOTE: Do not plug into outlet until instructed to do so.
Defermine Cabinef Opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to "Dishwasher Height Adjustment Chart"
for wheel position and the number of turns needed.
13