KitchenAid KUDS30FXWH1 Installation Instructions Manual page 14

Undercounter dishwasher
Hide thumbs Also See for KUDS30FXWH1:
Table of Contents

Advertisement

Available languages

Available languages

Dishwasher
Height Adjustment
Cha
Minimum,
Wheel
Number
of turns ' Perforation
cutout height
position
on front leg
on blanket
33si4,,(85:7cm)
' remove
' all the way up
I
remove:
I
!
I
337A" (86 cm)remove
all the way up
keep
341/2, (87i6 Ore)
NOTE: If the mimmum
cabinet opening
height is less than
34" (86.4 cm), the rear wheels can be removed
for
additional
clearance.
This will allow the dishwasher
to fit
into a 337/8 .' (86 cm) high cabinet opening,
but the
dishwasher
will be more difficult
to move. (Measurements
are approximate.
Wheels and legs are preset at the
factory for 341/2 .' [87.6 cm].) If the minimum
cabinet
opening
height is 33s/4" (85.7 cm), a section
in the
insulation
blanket can be removed
by cutting
along the
perforation.
Adjust wheels
and legs
Turn
both
leveler
legs to the same
height.
Put wheels
in
the required
position
determined
from
"Dishwasher
Height
Adjustment
Chart."
Built-up floors: If the kitchen floor is higher than the
cabinet opening's
floor - for example,
the kitchen floor tile
does not extend into the cabinet opening
- add shims as
needed in the area shown to bring the dishwasher
up to
34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement
when the dishwasher
is in use.
iii
iii i !iiiiiiiiiiiiiiiiiiiii_iiiii
.................................................................................................................................................
i_
Insfall the Door Handle
(on some models)
Mounting
stud
Handle
Setscrew
(in bottom
of handle)
Hex key
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware
bag containing
the
setscrews
and hex key from the cardboard
box. Setscrews
are already installed
in the handle. Place handle on
mounting
studs with the setscrews
facing down. Push the
door handle tightly against the door. Insert the short end
of the hex key into the setscrews. Tighten the setscrews
1/4
turn past snug.
Retain hex key with Installation
Instructions.
Cusfom
Panel Dimensions
'gSto
'¸';ons D;shwa
with control panel on the top
23%" --'_ _'-_
(60 cm)
*292%2'' (76 cm)
*This
dimension
is for 4" (10.2 cm) toe kick. If the
installation
needs a higher toe kick, adjust the height
of the wood panel accordingly.
Not recommended
for
toe kicks greater than 6" (15.2 cm).
,,
14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents