Any other use, e.g. as a form of heating, is an improper use of the oven and is therefore dangerous. If the model of oven is not fitted with a plug, fit a standard plug to the power cable. It must be The manufacturers cannot be held responsible for any damage caused by improper, incorrect able to bear the power supply indicated on the specifications plate.
Bottom and top oven elements are used. This is the traditional form of A flow of air will be projected from below the control panel when the oven thermostat is switched on. baking and roasting. It is ideal for roasting joints of meat and game, 50 ÷...
— Automatic operation (programmed beginning and end of cooking time) Select oven temperature and cooking function. To program not only the oven shut-off time, but also the cooking time (and hence the turn-on ti- Manual Operation (of the oven): me) the following steps must be performed:...
If the walls of the oven are so thickly coated in grease that the catalytic lining is no longer ef- Cleaning and maintenance fective remove surplus grease with a soft cloth or sponge soaked in hot water.
Page 6
HANDY TIP: Turn off the oven at least 10 minutes before the time shown, leaving the food in the oven. This way, you will save energy and be able to finish cooking the dish in such a way as to suit you. Lower the temperature so as to avoid the surface of the food becoming The overall suggested cooking times set out below are intended as a rough guide only.
Page 7
Meat All meats can be roasted in shallow or deep roasting trays. It is advisable to cover the shallow trays to avoid splattering the sides of the oven with grease will be crunchier. The roasting times are the same whether the meat has been covered up or not.
Page 8
(10 to heat up grill) of the bread has been toasted, turn over and toast the other side. Remember: keep the toast warm at the bottom of the oven until you are ready to serve it. Toasted sandwiches n. 4...
INSTALLATION OF OVEN PROTECTION TRIM Place the oven in its housing (under worktop or in column) inserting the frame (as per diagram) between the outer furniture edge and the oven side flanges. Complete the installation by securing the appliance with the 4 screws supplied.