Olympus LS-100 User Manual page 127

Troubleshooting
Symptom
Noise is audible
through the Acoustic feedback is occurring.
recording monitor
The maximum number of marks
(99) has been reached.
Unable to set index
The file is locked.
marks
The file is read-only.
Contains battery other than
the specified battery.
The battery is not properly
inserted.
Cannot recharge
USB class set to [Composite].
Cannot find files Wrong folder.
The recorder was wiped or shaken
during recording.
Noise heard during
The recorder was placed near a cell
playback
phone or fluorescent lamp while
recording or during playback.
The file is locked.
Unable to erase a file
The file is read-only.
There is a file that cannot be
Unable to erase a
recognized by the recorder in the
folder
folder.
The track is muted.
No sound is produced
from a certain track in
The output volume of the track
the Multi-Track Mode
is reduced.
Probable cause Action
When the built-in speaker amps and the like are
connected there is a risk that audio feedback will occur
while recording. It is recommended that you use a
headphone for the recording monitor.
Perform adjustments, such as further distancing the
headphone from the microphone, and not pointing
the headphone at the microphone.
Erase unnecessary marks ( ☞ P. 48).
Unlock the file ( ☞ P. 91).
Unlock the file or cancel the read-only setting of the file
on the PC.
Use the supplied rechargeable batteries.
Insert the battery properly.
Change the USB class setting to [Storage] ( ☞ P. 110).
Connect the recorder via USB while pressing and
holding the STOP button to recharge it ( ☞ P. 24).
Switch to the correct folder ( ☞ P. 34).
Move the recorder.
Unlock the file ( ☞ P. 91).
Unlock the file or cancel the read-only setting of the
file on the PC.
Connect the recorder to your PC and erase the folder.
Cancel the mute condition ( ☞ P. 61).
Increase the output volume of the track ( ☞ P. 62).
8
EN
127