Problem Solving - Kyocera FS-1018MFP Basic Operation Manual

Troubleshooting

Problem Solving

Problem
Nothing lights on the
operation panel when
the power switch is
turned on.
No copies come out
when [Start] is
pressed.
The copies are blank.
The copies are too
light.
7-2
The table below provides general guidelines for problem solving.
If a problem occurs with your machine, carry out the checkpoints and
procedures indicated on the following pages. If the problem persists,
contact your Service Representative or Authorized Service Center.
Checkpoint
Is the power plug connected to
an AC outlet?
Is there some indication of the
trouble on the operation panel?
Were the originals set
correctly?
Is the copier in Auto Exposure
Adjustment mode?
Is the copier in Photo,
Text+photo, or Text mode?
Is the copier in EcoPrint
mode?
Is the Add Toner indicator lit?
Is the copy paper wet?
Procedure
Connect the plug to an AC
outlet.
Check the appropriate
response to that indication and
perform the corresponding
procedure.
When setting originals on the
Platen, set them face-down.
When setting originals in the
optional Document Processor,
set them face-up.
In order to adjust the overall
exposure level, perform the
Auto Exposure Adjustment
procedure.
Adjust the exposure to the
correct level.
To adjust the overall exposure,
perform the corresponding
exposure adjustment
procedure.
Select an image quality mode
other than the EcoPrint mode.
Replace the Toner Container.
Replace the copy paper with
new paper.
BASIC OPERATION GUIDE
Reference
Page
—
Refer to page
7-5
Refer to page
4-2
Refer to page
5-4
—
Refer to page
4-2
—
—
Refer to page
6-3
Refer to page
3-2