Fuses; Replacing Headlight Lamp/Parking Light Lamp - KTM 625 SXC 2003 Owner's Manual

A
1
4
6

Fuses

Fuse box
See "Removing the seat" to remove and mount the seat.
The fuses are numbered on the inside of the fuse box.
The fuses marked "RES" are spare fuses.
Main fuse
circuits.
2
Fuse (10 Ampere) protects the following power-consuming units:
– electronic speedometer
– capacitor
3
Fuse (10 Ampere) protects the following power-consuming units:
– ignition
– starter system
4
Fuse (10 Ampere) protects the following power-consuming units:
– flasher lights
– brake light
– horn
5
Fuse (10 Ampere) protects the following power-consuming units:
– headlight
– parking light
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
ELECTRICAL INSTALLATION

Replacing headlight lamp/parking light lamp

Loosen both rubber bands
Pull the parking light lamp with holder
connector
3
retaining clip and take bulb out of reflector. When changing the parking-
light lamp, simply pull it out of the holder.
2
Insert the new lamp such that the noses
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the
parking-light lamp is to be replaced, simply insert it in the holder. Reinsert
the parking-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
5
the mask by means of the rubber bands.
A
is located under the seat.
1
(20 amperes) protects all power consumers against short
CAUTION
!
" ". A
REPAIRED N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
!
1
and tilt headlight mask to the front.
3
off the headlamp and remove rubber cap
!
2
carefully out of the reflector. Pull
4
. Disengage
5 6
engage in the recesses
35
.When