A
2
14
3
Compression damping of fork
The compression damping is to be set at the lower end of the fork tubes. It
only regulates the degree of damping during compression. Remove closing
A
cap
. By using the knob
compression can be adjusted. Turn the knob clockwise to increase damping,
turn it counterclockwise to reduce damping during compression.
STANDARD ADJUSTMENT:
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
WP 0518X729 ..................... 20 clicks
1
Rebound damping of fork
Hydraulic rebound damping determines the reaction when the fork is
2
rebound. By turning the knob
can be adjusted. Turn the knob clockwise to increase damping, turn it
counterclockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT:
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
WP 0518X729 ..................... 12 clicks
Compression damping of shock absorber
With the knob
adjusted. Turn the knob counterclockwise to increase damping, turn it
clockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT:
WP 0118X725 ................... position 3
Rebound damping of shock absorber
With the setting wheel
adjusted. Turn the knob to the left side to increase damping, turn it to the
right side to reduce damping during rebounding.
STANDARD ADJUSTMENT:
WP 0118X725 ................... position 5
4
1
(COM), the degree of damping of the
2
, the degree of damping of the rebound
3
the degree of damping of the compression can be
4
the degree of damping of the rebound can be