Table of Contents
Advertisement
KORG D12 Guided Tour
Press [END/LOC4] to reset the song to the beginning, then press [PLAY] to begin playback.
1.
Press [MASTER EFFECT/AUX] until you select the "FinalEff" tab, and note that "F019 LS2:TwoMix80's" is the effect
2.
assigned.
u to the "Bypass" button, and repeatedly press
3.
Press
ENTER
to "Cancel" Bypass and recall the Final effect.
4.
u to highlight "F019", and rotate the [DIAL] to audition new Final effects while the song plays. When you've selected a Final
5.
effect that you like, u to the "effect" button to the right of the effect number and press ENTER, then u to the effect "icon",
press ENTER, and select and edit the parameters to suit.
of edit parameters
available.
Store the new Final effect in a user location:
Once you've completed editing desired parameters, u to the "OK" button, and press
6.
u to the "Rename" button and press ENTER, then press
7.
desired "buttons" in the display. Use the [DIAL] to enter a new name for the edited effect.
u to the "OK" button, press ENTER, then u to the "Store" button in the display, and press ENTER.
8.
u to highlight "u033" (the first user effect), and rotate the [DIAL] to select "u040 DY2: StudioLimitr", then u to the "Exec."
9.
button and press
ENTER
this song.
Playback the song and make any final mix changes:
Press [END/LOC4] to reset the song to the beginning, then press [PLAY], and set the faders, pan/balance knobs, EQ and
1.
effect settings for a final mix
When you're satisfied with the mix, press [STOP] and reset the song to the beginning.
2.
Store a new initial Scene for the song:
Press [STORE], then press [SCENE], to write the new scene at the beginning of the song. Press [SCENE] until you select the
1.
"ReadDel" tab, and the display will indicate "002:NEW SCENE" (there was a previously stored scene in the copied demo
song).
Press
ENTER
so that "SceneRead:Off" reads "SceneRead:On". The [SCENE] key will light, and your new mix will be stored in
2.
memory (and automatically saved on power-off).
song, and the initial SCENE will be recalled.
Tip:
You can view Scene fader and pan settings from scene to scene, by turning "SceneRead:Off", and selecting the
"MixView" tab. Then
display will indicate the pan/ balance and fader changes.
Tip:
Scene changes (up to 100 per song) can be transmitted and received via MIDI program change messages. For more
information on Scene mode operations, see the D12 Owner's Manual, pg. 41.
ENTER
to store the effect.
Note: The new assigned effect is now indicated in the display and is stored with
setup. (Track playback EQ is accessed with the EQ/PHASE key and the EQ tabs in the display).
The next time you power-on, the [SCENE] key will light when you select this
to highlight the "Scene number" and use the [DIAL] to move from scene to scene - the MixView
to listen to the song without and with the Final effect.
Note: The "Next:" or "Prev" buttons in the display select the pages
ENTER
to move through the effect name cell, and u to select
22
ENTER
2x, then press [STOP].
Advertisement
Table of Contents
