Quick Installation - Tripp Lite OMNISMART Owner's Manual

200607050 93-2490 OmniSmart ISO Update.qxd

Quick Installation

1 Connect your UPS to
an electrical outlet.
Your UPS will run a self-test after it is
plugged in. See Basic Operation to understand
the results of its self-test.
2 Plug your computer, monitor
and other equipment into
the UPS system.
Your UPS is designed to support only com-
puter equipment. You will overload your UPS
if you connect high power draw equipment
such as household appliances or laser printers
to outlets providing UPS battery backup.
Select models feature special outlets (clearly
labeled on the rear panel) which provide
surge-only (not battery backup) protection
designed for laser printers and other heavy-
draw devices.
3 Select UPS Operating Mode.*
Press the ON/OFF button to toggle your UPS
between the UPS ("
CHARGE ONLY ("
modes. Choose the operating mode based on
your location:
USA, Canada & Western Europe:
• Leave the UPS in the UPS mode at all times.
All other countries:
• Put the UPS in the CHARGE ONLY
mode when you are not using connected
equipment.
(WARNING! When set to "CHARGE ONLY," the UPS
will not provide battery backup during a blackout
or brownout)
• Put the UPS in the UPS mode when you
are using connected equipment.
*See Basic Operation section for a complete explanation
of each mode.
7/26/2006
1
2
" LED lit) and the
" LED flashing)
3
3
11:39 AM Page 3
Model Shown: OMNI500ISO