Adjust Timer Clutch; Changing Vend Price (For Coin Slide Mechanism Provided With Washer) - Kenmore 11026152500 Installation Instructions Manual

.,_i_i:! i i:_il _!!ii_ _i::i fl_ ii!il ¸' ii ¸ ' i _i_ !fli_i:!_ ii_ _,_iiill iiii ,_:_il i::_i" !l_
All coin operated models have a timer that provides a 9!/2-minute
wash in the NORMAL Cycle, To check the cycle, push the coin
slide all the was' in and pulI all the way out. Note the wash cycle
time, if the washer does not start or does not provide the proper
wash time, the clutch assembly may need adjustment.
Emectcical Shock Hazard
Disconnect power before servicing,
Replace aH parts and panels before operating.
Failuce to do so can result in death or emectrical shock.
NOTE: The washer was tested at the factory. Some time may
have been Ieft so that the washer will start to operate before the
coin slide is operated. If this happens, take off the access panel
from the top of the meter case and set the clutch to OFF position
by hand. Then proceed with timer clutch check.
To adjust the clutch:
f, Unplug washer or disconnect power.
2, Remove the meter case access panel,
3, The clutch assembly has a timer clutch adjustment screw. If
the washer does not start after the coin slide has been
pushed a!I the way in and out, turn the clutch adiustment
screw clockwise (right).
4, If the timer goes past the third increment of fill, less than 91A -
minutes of wash will be provided in the NORMAL Cycle. Turn
the clutch adjustment screw counterclockwise (left).
B C
\
A ........
D
A, Timerfront
B. On
C. Off
D. Rotatecounterclockwise
E. Tirnerclutchacl/ustment s crew
fi: (,
w
NOTE: For any other type of money-accepting device, please see
the manufacturer's instructions to change vend price.
Electdcam Shock Hazard
Disconnect power before serv{cing,
Repmace aH parts and panels before operating,
Failure to do so can resumt in death or electdcam shock.
f° Unplug washer or disconnect power,
NOTE: PIace all screws and other items removed from coin slide
assembIy on a cloth so they will not get Iost.
2, Remove service door from meter case,
3, Remove chute bott from slide mechanism and remove slide
mechanism from meter case.
A, Chute bolt
B. Coin slide mechanism
C. Access
4, Unhook and remove slide return spring.
5, Place coin(s) in coin slot(s) and push forward all the way,
Remove 2 screws securing buffer and detach buffer,
A
A. Buffer
:_::: , ....
,/