Table of Contents
Advertisement
iNSTALLATiON iNSTRUCTiONS
NOTE: To prevent floor damage, set the washer onto cardboard
before moving across floor.
Remove tape that covers shipping strap. Pull to completeSy
remove the shipping strap with 2 cotter pins from the inside of
the washer.
[]
[]
Use new hoses and washers that came with your washer.
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Inspect and replace inlet hoses if bulges, kinks,
cuts, wear, or leaks are found. When replacing your inset
hoses, mark the date of replacement on the Sabelwith a
permanent marker.
Connect
the inlet
hoses
to the washer
1. Insert a fiat washer into each end of the inset hoses. Check
that washers are firmly seated in coupSings.
A
B
A. Coupling
B. Washer
Attach a hose to the hot water inlet valve. Tighten the
coupling by hand.
2,
A, Shipping tape
B, Shipping strap
Pull firmSy to remove the end of shipping strap from the back
of the washer. The shipping strap piug must be completely
removed from the washer for the self-leveling legs to be
released.
Save the shipping strap for later use.
A. Cold water inlet valve
B. Hot water inlet valve
3. Attach the other hose to cold water inlet valve. Tighten the
coupling by hand.
4. Use pliers to make an additional two-thirds turn.
NOTE: Inlets valve threads are plastic. Do not strip or cross-
thread.
Advertisement
Table of Contents
