Placement Of Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - Samsung SMH7177STE/XAA Installation Instructions Manual

Over the range microwave oven
Table of Contents

Advertisement

Installation
Instructions
1. PLACEMENT OF THE MOUNTING PLATE
All
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1.
Remove
the installation
instructions,
filters, glass
tray and the small hardware
bag. Do not remove
the Styrofoam
protecting
the front of the oven.
2. Fold back all 4 carton flaps fully against carton
sides. Then carefully
roll the oven and carton over
onto the top side. The oven should
be resting in
the Styrofoam.
3. Pull the carton up and off the oven.
4. Remove
and properly
discard plastic bags.
Screw
Screw
!
Mounting
Plate
5. Remove
the 2 screws from the mounting
plate.
This plate will be used as the rear wall template
and for mounting.
NOTE: You will have to be reused
one screw when
you will install blower for outside
back exhaust.
(Type page 17)
B.
FINDING THE WALL STUDS
l
ill
iW." all Studs
1
1. Find the studs, using one of the following
methods:
A. Stud finder-a
magnetic
device which locates
nails.
OR
B. Use a hammer
to tap lightly across the
mounting
surface
to find a solid sound. This
will indicate a stud location.
2. After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway
between
the edges. The center of any adjacent
studs
should
be 16" or 24" from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE
MUST BE CONNECTED
TO AT
LEAST
ONE WALL STUD.
8

Advertisement

Table of Contents
loading

Table of Contents