Table of Contents
Advertisement
Installation
Instructions
C3_ CHECK MICROWAVE
ASSEMBLY
Exhaust
Adaptor
(absent on models shipped
for
recirculation
exhaust)
i
°*°
"
of
',
Microwave
•
Place the microwave
in its upright
position,
with
the top of the unit facing up.
•
The microwave
oven may be shipped
assembled
for top exhaust
(adaptor
installed)
or for
recirculation
exhaust
(adaptor
absent).
•
If the microwave
was shipped
for recirculation
exhaust,
skip to C5. If shipped
for top exhaust,
proceed
with C4.
04_ ADAPTING
MICROWAVE
BLOWER
FOR RECIRCULATION
4/. Remove
and save
2.
Lift up the
screw that holds
blower
r)late.
blower plate to
m icrowave
ii_,"
........... .-':::."
_
Back of
......
_
Microwave
Screw
NOTE: The exhaust
adaptor
with damper
is not
needed for recirculating
models.
You may want to
save them for possible
future use.
3. Carefully
pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
CAUTION:
Do not touch blade of blower for
preventing
crack and break. Hold outer case when
the blower
pull out or back into.
4. Roll the blower
unit 90 ° so that fan blade
openings
are facing toward the front of the
microwave.
Roll
5. Place the blower
unit back into the opening.
CAUTION:
Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6. Secure
blower
unit to microwave
with the screw.
20
Advertisement
Table of Contents
