Hilti HIT-ED 3500-A Operating Instructions Manual

Hilti HIT-ED 3500-A Operating Instructions Manual

Hide thumbs Also See for HIT-ED 3500-A:

Advertisement

9
10
1
2
11
1
2
Hilti Corporation
LI-9494 Schaan
Tel.: +423 / 234 21 11
14.4 Volt Li-Ion
Fax: +423 / 234 29 65
2.6 Ah
www.hilti.com
Hilti = registered trademark of Hilti Corp., Schaan W 3586 1208 00-Pos. 1 1 Printed in Liechtenstein © 2008
Right of technical and programme changes reserved S. E. & O.
360404 / B
HIT-ED 3500-A
Bedienungsanleitung
de
Operating instructions
en
Mode d'emploi
fr
Istruzioni d'uso
it
Manual de instrucciones
es
Manual de instruções
pt
Gebruiksaanwijzing
nl
Brugsanvisning
da
Bruksanvisning
sv
Bruksanvisning
no
Käyttöohje
fi
Instrukcja obsługi
pl
Kulllanma Talimat›
tr
Lietoßanas pamåcîba
lv
Instrukcija
lt
Kasutusjuhend
et
ja

Advertisement

Table of Contents
loading

Summary of Contents for Hilti HIT-ED 3500-A

  • Page 1 Instrukcja obsługi Kulllanma Talimat› Lietoßanas pamåcîba Instrukcija Kasutusjuhend 360404 / B Hilti = registered trademark of Hilti Corp., Schaan W 3586 1208 00-Pos. 1 1 Printed in Liechtenstein © 2008 Right of technical and programme changes reserved S. E. & O.
  • Page 2 14.4 Volt Li-Ion 2.6 Ah 500 ml 330 ml XX/20XX...
  • Page 3: Table Of Contents

    Ensure that the operating instructions are Parts, operating controls and indicators 1 with the tool when it is given to other Static mixer for use with Hilti foil packs (please refer to the corresponding instructions for use) persons. Hilti foil pack...
  • Page 4: Description

    2.1 Use of the product as directed The ED 3500‑A cordless dispenser is to be used exclusively with Hilti foil packs in 330ml or 500ml sizes. The tool is designed to dispense the contents of Hilti foil packs in a controlled operation. The tool is equipped with a holder for Hilti foil packs.
  • Page 5: Accessories

    LEDs light constantly LEDs blink Charge status C 25 % ≦ C < 50 % LED 1,2 10 % ≦ C < 25 % LED 1 LED 1 C < 10 % LED 1 Battery overheated 3. Accessories Battery B 144/2.6 Li‑ion Charger C 4/36 or C 4/36‑ACS 4.
  • Page 6: Safety Instructions

    Battery B 144/2.6 Li‑ion Deep discharge protection Type of cell Lithium-ion No. of cells 5. Safety instructions The safety rules in section 5.1 contain all general d) Do not abuse the cord. Never use the cord for safety rules for power tools which, in accordance carrying, pulling or unplugging the power tool.
  • Page 7 f) Dress properly. Do not wear loose clothing or b) Use power tools only with specifically designated jewellery. Keep your hair, clothing and gloves battery packs. Use of any other battery packs may away from moving parts. Loose clothes, jewellery create a risk of injury and fire.
  • Page 8: Before Use

    Before inserting the battery, check that the selector be used are at room temperature before work begins. switch is in the “off” position. Use only the Hilti The battery must be kept warm, i.e. within its normal batteries approved for use with this power tool.
  • Page 9: Operation

    1. Pull the piston rods back fully while pressing the position during transport or storage. release button. Use of genuine Hilti parts ensures maximum safety. 2. Grip the foil pack holder by the small cylinder and The dispenser, the foil pack holder and the foil packs insert it into the tool from above, tipping it slightly are perfectly matched to each other.
  • Page 10: Care And Maintenance

    2. Push up the small cylinder through the opening WARNING! Pull the trigger and hold it in this position and then remove the complete foil pack holder. until the dispenser switches itself off. This will ensure that a full stroke is dispensed. 7.6 Disposing of a foil pack 1.
  • Page 11: Troubleshooting

    Check all external parts of the appliance for damage before the battery cells suffer damage. at regular intervals and check that all controls operate Charge the battery with the Hilti charger approved for faultlessly. Do not operate the appliance if parts use with Li-ion batteries.
  • Page 12: Disposal

    Dispose of the batteries in accordance with national regulations or return them to Hilti. Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back old tools and appliances for recycling.
  • Page 13: Manufacturer's Warranty

    11. Manufacturer’s warranty Hilti warrants that the tool supplied is free of defects Additional claims are excluded, unless stringent na- in material and workmanship. This warranty is valid tional rules prohibit such exclusion.

Table of Contents