Removing Stainless Steel Front Panel From The Freezer Compartment Drawer; Aligning The Appliance - Thermador T361T71FNS Installation Instructions Manual

10. 11. Aligning the appliance Removing stainless steel front panel
from the freezer compartment
drawer
iiiiiii
Loosen and unscrew nuts on the top of the door,
However, do not turn the threaded bolts, otherwise
the door will no longer be aligned.
Do not loosen the screws on the left and right fixing
brackets. Do not unscrew the screws!
@
@
Pull the bottom of the stainless steel front panel away
from the door to remove the fixing brackets from the
screws. Then lift the door off the threaded bolts.
Place fixing brackets only loosely into the plates.
Ensure that you do not lose them.
Never use a cordless screwdriver!
Risk of damage to the appliance.
- Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
- The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
- If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
Remove base panel from the appliance.
Align the appliance with the furniture fronts.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front: with open-ended wrench 1/2" (SW13)
Rear: with 5/1G"(8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 11/4" (32 mm) above the
floor.
18