Removing The Packaging - Thermador T361T71FNS Installation Instructions Manual

3. Removing the packaging
- The appliance may tip over while it is being
unpacked.
- The appliance is very heavy.
- When opening the appliance door, the appliance
may tip forwards.
Be careful, otherwise people who are helping may be
injured or the appliance may be damaged.
To protect the base from damage during installation:
Attach a residual piece of carpet, lino, etc. to the floor
with adhesive tape in front of the intended installation
location.
Do not remove transportation protection device (A)
from the underside of the freezer compartment drawer.
Do not remove transportation safety devices which
protect the shelves and storage compartments inside
the appliance until the installation is complete,
otherwise the parts may be damaged.
A
Check appliance for damage in transit.
Do not install the appliance if it is visibly damaged. If in
doubt, contact your dealer.
@
@
Move the appliance with a hand truck securely.
Remove transportation packaging:
- Using adhesive tape, attach the power cord to the
back of the appliance.
- Remove transportation protection devices and lift
appliance off the pallet - appliance is very heavy!
- Remove accessories from the outside of the
appliance.
- Keep adhesive tape which was used to attach the
supplied accessories to the appliance.
It is used subsequently for attaching the edge
protection to the cavity walls (see Section 8.).
- Carefully open the appliance- risk of tipping over-
and remove accessories and installation materials
from inside the appliance. Close doors again!
Care should be taken when closing the door. The
folding rail attached to the door of the refrigerator
compartment has to be folded if the door are closed.
Risk of damage!
13