Trouble-Shooting Answer To Question - Haier HWMP50F User Manual

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The
following phenomena are not breakdowns sometimes. Please confirm again
before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not
repair it by yourself.
Phenomenan
The digitron displays E0.
The drainage cannot work,
or is too slow.
The digitron displays E1.
It stops running in midway.
The digitron displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
The water filling does
not work, or is slow. After
about 30 minutes later,
the digital displays E4.
The digitron displays E6.
Not wash
The machine
does not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
The reason
The top lid is opened
during reserve procedure.
Is the drain hose
blocked?
The top lid is not closed.
Are the laundries put
slantingly?
Is the machine slanting?
Is the water tap opened, or
is there water supply failure?
Is the water inlet valve
blocked?
Is the water pressure too
low?
The water level sensor is
bad.
Is there power failure?
Is the power plug inserted
tightly?
Is the water level reached
preset position?
Is the power plug inserted
tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly
in spinning?
Are there any foreign materials?
Is the screw of the jointer of
water inlet hose loose or awry?
12
How to settle
Close the top lid.
Clean the foreign material. Open
and close the top Lid Once.
Close the top lid.
Reorder the laundries.
Close the top lid.
The machine will start
running after 10 seconds
of being placed horizontally.
Open the water tap. Push
the start/Pause button once.
Clean the water inlet valve
then push the start/Pause
button once.
Push the sStart/Pause
button once.
Please contact the
after-sales service
department.
Please use it when there's
power supply.
Insert the power plug
tightly.
Fill water to the preset
position.
Insert the power plug
tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Reorder the laundries and
close the top lid.
Remove the foreign materials.
Fasten the screw of the
jointer properly.