Whirlpool YSF379LEKQ0 Installation Instructions Manual page 15

_ reinstall one
orifice of the
[] Surface Burners: spud _ screws
Remove
burner caps. Use ... \ _ snark electrode
a Phillips or Quadrex s°p'_'_ e _ ""
/
screwdriver
to remove holder _///Tx/"/_r_._%_\\_.,_,x\\ _/._
the two screws holding the __'_b_
burner head down. Lift the \\\'_//_
burner head off the cooktop _
to uncover the orifice spud range cooktop
holder.The orifice spud is recessed in the holder.
Note: Reinstall one of the screws through the range cooktop
to hold orifice spud holder in place while removing and
replacing orifice spuds.
Locate the Natural gas orifice spuds in
literature package. Orifice spuds are
stamped with a number and marked with
two color dots.
5/16" (7 ram)
nut driver
Nature[ gas
orifice spud
orifice spud _ __
Replace orifice _-.._,_
spud with the _
number listed
in chart, x
orifice
number
burner
assembly
Natural Gas
Surface Natural Gas Orifice Color
burner Rate(BTU/hr) Number Marking
Left rear 8,000 N139 Blue/Black
Left front 13,500 N186 Blue/Orange
Right front 9,500 N151 Bhe/Brass
Right rear 5,000 Nl12 Blue/White
Locate the brass orifice spuds in the center of each burner
throat about 2" (5 cm) below the cooktop. Apply masking
tape to the end of a 5/16" (7 ram) nut driver to fit snugly over
the orifice spud. Press driver down onto the spud of the left
front burner and remove by turning spud counter-clockwise
and lifting it out. Replace the L.R gas spud with the
appropriate Natural gas spud shown in the table.
Continue to replace the remaining orifice spuds, one at a
time. Place the L.R gas spuds in plastic parts bag for future
use and keep with literature package. Replace burner caps
using both screws and burner grates.
pin __ hood
zt I L.R gas
\ /decrease
Natural gas _ gas
increase gas_ decrease /,
increase _ flame size
flame size
pro-set at
factory for
Natural gas
J
_hood
[] Oven burner: Use 1/2" (13 mm) combination wrench to
loosen the orifice hood away from pin (approximately 2 to
2-1/2 turns).The burner flame cannot be properly adjusted if
this conversion is not made.
/-----------m------_ ..................
[] Broil burner: Use 1/2" (13 mm) combination wrench to
loosen orifice hood away from pin (approximately 2 to
2-1/2 turns).The burner flame cannot be properly adjusted if
this conversion is not made.
[] Reinstall the storage drawer. Complete installation
sections D through E, Pages 9-13. Checking for proper
cooktop burner and oven flame is very important.
YOU MUST ADJUST "LOW" SETTING FOR EACH COOKTOP
BURNER. SEE STEP 16, PAGE 10.
Natural gas flames do not have yellow tips.
Page 15