Secure The Drain Hose - Whirlpool CHW9900WQ0 Installation Instructions Manual

1.
2.
3.
4.
, iili i i :' i! !iiiii i i ii ililili!!!i i, !iii! : ¸
Drape the power cord over the washer top.
Move the washer to its final location.
Place the drain hose in the laundry tub or standpipe as
shown. See illustrations A and B.
If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
!:I
A B C
NOTE: For PD Models only.
1. Take the 2 foam pad strips from bag.
2. Remove tape from the back of adhesive pads.
3. Install the pads on the left and right inside walls of the coin
vault, leaving about 1/4" to 1/2" of space near the front
edge of the vault to allow room for the coin box to lock into
position.
NOTES:
[] Secure the drain hose using the supplied beaded strap.
[] Do not force excess drain hose back into the rear
of the washer.
[] To avoid siphoning, do not seal the drain hose into
the standpipe.
Properly leveling your washer avoids excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
2.
3.
4.
5.
6.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat
this step until washer is level.
Make sure all four feet are stable and resting on the floor.
Then check that the washer is perfectly level (use a level).
After the washer is level, use a 9/16" open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts
are not tight against the washer cabinet, the washer may
vibrate.
The washer should not move front to back, side to side,
or diagonally when pushed on its top edges.
Slide the washer to its final location.
Confirm the levelness of the washer.
1.
2.
3.
4.
5.
6.
A. Foam pad strips
Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
Check that you have all of your tools.
Dispose of/recycle all packaging materials.
Check that the water faucets are on.
Check for leaks around faucets and inlet hoses.
7.
8.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet.
To test and to clean your washer, measure 1/2 the detergent
manufacturer's recommended amount of "HE" High
Efficiency detergent for a medium-size load. Pour the
detergent into the detergent dispenser. Select any cycle and
allow the washer to complete one whole cycle.
Use only HE High Efficiency detergent.