JVC NX-F7 Instructions Manual page 53

NX-F3_NX-F7[A]EN.book Page 50 Tuesday, April 22, 2008 1:55 PM
5
Release [DBS/VCR F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change with-
out notice. You may not be able to operate the
VCR produced by the manufacturer.
• After replacing the batteries of the remote con-
trol, set the manufacturer code again.
Using the remote control for the
VCR operation
Before the VCR operation, select the remote con-
trol mode for the VCR.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [VCR].
2
Operate the remote control by
pointing it at the VCR.
Remote control button Usage
[DBS/VCR F]
[CH +/ ]
–
Number buttons
(1-10, 0, 10)
3 (playback)
7
8
¡
1
[REC] + 3 (playback)
[REC] + 8
NOTE
• When the remote control mode selector is slid to
the lowest position and [VCR] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
Turns on/off the VCR.
Changes channels.
Selects the channels.
Starts playback.
Stops playback.
Pauses playback.
Fast-forwards the tape.
Fast-rewinds the tape.
Starts recording.
Pauses recording.
For the locations of the remote
control buttons, refer to page 47.
50