JVC NX-F7 Instructions Manual page 14

NX-F3_NX-F7[A]EN.book Page 11 Tuesday, April 22, 2008 1:55 PM
Preparation (continued)
NOTE
• "480", "576", "720" and "1080" refer to the num-
ber of the scanning lines. Generally, the larger
the number, the better picture that can be
obtained.
• "I" refers to the interlaced format. "P" refers to
the progressive format. A better picture can be
obtained in the progressive format than in the
interlaced format.
• When an HDMI video signal is output, the
"HDMI" indicator lights up in the display window.
• When an HD video signal is output, the "HD"
indicator lights up.
• When "PAL. 576P", "PAL. 720P", "PAL.1080P",
"NT. 480P", "NT. 720P" or "NT.1080P" is
selected, the "PROGRESSIVE" indicator lights
up in the display window.
5
Press [ENTER].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after selecting
the video signal type. Most of the other functions
can be used when the remote control mode
selector is at [AUDIO].
• To check the compatibility of your TV, contact
your local JVC customer service center.
• Even if the main unit is turned off, the video sig-
nal type setting is stored.
11
Do not connect the power cable until
all other connections have been made.
For the locations of the remote
control buttons, refer to page 10.