JVC UX-G980V Instructions Manual page 4

Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete
understanding and to obtain the best possible performance from the System.
Precautions
Installation
• Install the System in a location with adequate ventilation
to prevent internal heat build-up in the System.
DO NOT install the System in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or vibration.
• Install in a place which is level, dry and neither too hot
nor too cold—between 5°C and 35°C.
• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid
interference with the TV.
Power sources
• When unplugging the System from the wall outlet, always
pull on the plug, not the power cord.
DO NOT handle the power cord with wet
hands.
Moisture condensation
Moisture may condense on the lens inside the System in the
following cases:
• After starting to heat the room
• In a damp room
• If the System is brought directly from a cold to a warm
place.
Should this occur, the System may malfunction. In this
case, leave the System turned on for a few hours until the
moisture evaporates, unplug the power cord, then plug it
in again.
Internal heat
• Make sure there is good ventilation around the System.
Poor ventilation could overheat and damage the System.
DO NOT block the ventilation openings or
holes. If they are blocked by a newspaper or
cloth, etc., the heat may not be able to get out.
Others
Should any metallic object or liquid fall into the System,
unplug the power cord and consult your dealer before
operating any further.
DO NOT disassemble the System since there
are no user serviceable parts inside.
• If you are not going to operate the System for an
extended period of time, unplug the power cord from the
wall outlet.
If anything goes wrong, unplug the power cord and consult
your dealer.
1
Introduction
How to Read This Manual
• Button and control operations are explained in the table
below.
• Some related tips and notes are explained later in
the sections "Learning More about This System"
and "Troubleshooting," but not in the same section
explaining the operations (
content has some information).
2
sec.
Remote
ONLY
Main Unit
ONLY
How to cancel the demonstration
Press and hold DEMO on the main unit (until "DEMO
CLR" appears on the display) while on standby.
• Refer to the attached sheet "Information about the
demonstration function."
Supplied Accessories
Check to be sure that you have all the following items.
• FM antenna (×1)
• AM loop antenna (×1)
• Remote control:
– RM-SUXG980VU (×1) (Regions other than Australia)
– RM-SUXG980VA (×1) (Australia only)
• Batteries (×2)
• AC plug adapter (×1) (not supplied for Australia,
Thailand, Hong Kong region and the Middle East)
If any items are missing, consult your dealer immediately.
INFO
indicates that the
Indicates that you press the button briefly.
Indicates that you press the button briefly
and repeatedly until the option you want
is selected.
Indicates that you press one of the buttons.
Indicates that you press and hold the
button for a specified period.
Indicates that you turn the control in the
specified direction(s).
Indicates that this operation is only
possible using the remote control.
Indicates that this operation is only
possible using the main unit.