Download Print this page

Haier XQG50-S1016 Operation Manual page 5

Haier automatic drum washing machine operation manual

Advertisement

Warning code
Warning
Abnorma item
Content of identification
code
The water level can not
reach the reset water
level within 5 minutes
E11
Water supply
The water level can not
reach the setting water
level within 8 minutes
The water level can not
reach the reset level in
E12
Drainage
8 minutes after drainage
starting
The water is above the
E13
Water supply
warning level
The feedback signal do-
E31
Motor
es not change in 8 minu-
tes during the motor runs
Water level is
The water is ablove the
EA3
abnormal in the
setting water level during
drying process
the drying process
The water temperature
EC1
Heater
unchanged in 10 minutes
Water tempera-
The drying sensor circuit
EC2
ture sensor
short cut or open
Water level
The water level sensor
EC3
sensor
circuit short cut or open
Within 30 minutes of dry
The temperature
phase there is 5 minutes
EC4
of air vent
in which the temperature
is not increasing
The dry tempe-
The heater sensor circuit
EC5
rature sensor
short cut or open
Can not unlock after 4
U01
Unlock the door
times try
Can not lock the door
U02
Lock the door
after 4 times try
The judgement of un-
U03
Spin lopsidedly
balance is above 1000g
U04
Unclose the door
The door is unclosed
The memory
E22
EEPROM goes wrong
function is failure
14
Checking position and
Action to take
ask for help
Check if the water
Warning and
pressure is low or stops
stop running
supplying
Check if the water
Warning and
pressure is low or stops
stop running
supplying
Check if the water outlet
Warning and
of the drainage and
stop running
adjust it and restart the
machine
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Check if the water outlet
Warning and
of the drainage and adjust
stop running
it and restart the machine
No heating and
Ask the technician to
washing with
repair
cold water
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Warning and
Ask the technician to
stop running
repair
Spin low speed
Disperse the clothings
and cancel
evenly in the tube
drying
Warning
Close the door
Ask the technician to
Warning
repair
Matters needing attention
3. Never place heavy objects, e.g. a heating
appliance or water container, on the top panel
of the washing machine.
5. Before washing, close zippers, buttons,
laces and repair damaged areas. Underwear
and amall items should be palced in a laun-
dry bag or pillow slip. Do not wash clothes
containing wire frames.
7. The door is fitted with a self-locking device
and can be opend when it is under the safety
state ( water should be under the safe level;
temperature inside the drum should be less
than 55 ; the drum should do not run). Do
not open the door except above condition
otherwise the self-locking device will be
damaged and the operator will get hurt.
9. Keep the door slightly open when the wa-
shing machine is not being used. Never cover
the machine a
plastic sheet.
4. Do not wash foam rubber or simalar sponge
materials.
6. Do not open the detergent dispenser during
the wash cycle. Otherwise, the water will spilt
out from it and the detergent can not be wash-
ed out completely.
8. After washing, turn off the tap to prevent
leaking; unplug the washing machine and
wipe clean the lower part of the porthole.
10. The tumble dryer should not be used if
industraial chemicals have been used for
cleaning
11. The appliance must not be installed behind
a lockable door, a sliding door or a door with
a hinge on the opposite to that of the tumble
dryer.
3

Advertisement

loading